(, )ĪVAILABLE: blackmagic, cmsis-dap, dfu, jlink, serial, stlink The results might differ compared to plain JTAG/SWD Info : The selected transport took over low-level target control. pio\build\genericSTM32F103C8\firmware.elf : Advanced Memory Usage is available via "PlatformIO Home > Project Inspect" When I try to upload the code in Platformio on VSCode using the icon button (right pointing arrow), this is the output (the tail end of it). This also compiles without issue in Platformio on VSCode with no issues. This application works as expected when compiled and uploaded using the Arduino IDE v 1.88. The code I am uploading is a simple blink program. If someone can direct me to where I can read up on how to get the output from the Arduino IDE then I will be happy to include that here as well. If anyone that has solved this can point me in the right direction, I would certainly appreciate it! I want to use VSCODE for ALL my work, and will be happy to put the Arduino IDE behind me. I have researched that also, but only today. I will humbly admit that there is a lot I have not looked at and tried, because I do not know where I can find a log of the upload handshake from the Arduino IDE, or what command line parameters to use with the CLI version. I have not tried to upload the firmware using the ST-LINK Utility CLI or the GUI because I do not know how. I can also successfully communicate with the board using the ST-LINK Utility v4.0.0. Again, it works with other methods, just not VSCODE/PLATFORMIO.Īlthough I can successfully upload to my STM32F103C8 (128k) blue pill clone boards using Arduino IDE v1.88, I cannot using Platformio on VSCODE. I shortened them to 3 inches and still have the same issue. I read another thread here where the OP had very similar issues to mine and they marked it solved based on wire length, but that is not the issue here. I am using 4 lines (3.3v, gnd, SWO, and SWCLK). I am connected to a clone bluepill STM32F103C8 board with 128k using the attached STLINK SWD interface on a Nucleo F411RE development board. I have read through so many threads over the last few weeks and have still not been able to resolve this issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |